www.vax.co.uk
4
preparing the carpet / assembly
3. Preparing the Carpet
IMPORTANT: Do not use the Carpet Washer as a
dry vacuum.
1. Vacuum carpet thoroughly. Use a vacuum cleaner
with a revolving brushbar for best results.
2. Remove as much furniture from the room as
possible. If unable to remove the furniture, place
plastic or foil under and around the legs until the
carpet has dried completely.
Helpful Hints for Carpet Cleaning:
1. Only use Vax ULTRA Carpet Cleaner with this carpet
washer.
2. Do not oversaturate carpet with cleaning solution
while using the carpet washer.
3. For heavily soiled areas, additional applications may
be necessary.
4. Allow plenty of time to dry carpet thoroughly.
5. Wipe cleaning solution from woodwork and wood
to prevent any damage.
6. Try not to walk on carpet until it is completely dry.
7. After carpet is thoroughly dry, vacuum the carpet
using a vacuum cleaner with a revolving brushbar.
8. Before cleaning, determine where to start and end,
making sure not to walk over previously cleaned
areas.
Check for Colour Fastness:
Before cleaning carpet, test for colour fastness. Dampen a
white cloth with solution. Test a small area in a closet.
Gently rub the cloth over the area. Check each colour for
colour bleeding. If the cloth remains clean, it should be
safe to clean the carpet.
After Cleaning:
• Allow carpet to dry completely. Try not to walk on
the carpet until it is dry.
• If it is necessary to walk on the carpet, place white
towels on the areas to be walked on.
• If the carpet is not dry and the furniture must be
placed back in the room, use plastic or foil under
the furniture to prevent staining the carpet.
• Thoroughly clean the dirty water tank with warm
(max 40ºC) tap water.
4. Assembly
Push Solution Tube Cylinder Connector (A) firmly into
Solution Port (A1).
Twist Solution Tube Cylinder Connector (A1) a quarter
turn to the right to lock into place (Fig.4/1).
Push Hose Cylinder Connector (B) firmly into Hose
Connection Port (B1).
Twist to the right until Hose Cylinder Connector Locks
into place (Fig.4/2).
Wrap Solution Tube (A) around Hose (B). Ensure that
the solution tube is wrapped loosely enough to allow
the solution to flow freely through the tube (Fig.4/3).
Fig.4/3
A
B
Fig.4/1
A
A1
Fig.4/2
B1
B
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji